Hydraulic cylinder sizing starts by converting machine load into the thrust required at the worst geometry. Pressure and piston area set theoretical force; pressure loss, friction, acceleration and a design margin must be considered before selecting a bore.
Push Force From Bore and Pressure
For extension on full piston area, theoretical force equals pressure multiplied by piston area. Use pressure expected at the cylinder during the working stroke, not the relief setting as though it were guaranteed continuous pressure.
| Input | Engineering question | RFQ field |
|---|---|---|
| Required push force | What thrust is needed at the worst linkage angle? | Maximum working load + geometry |
| System pressure | What pressure is available at the cylinder? | Normal pressure + relief setting |
| Colpo | What travel is required? | Stroke + retracted envelope |
| Speed | How fast must it move under load? | Extend/retract time or velocity |
Retraction Uses Annulus Area
Double-acting retraction uses piston area minus rod area. Retract force is lower and, for the same flow, retract speed is usually higher. Check both directions.
Check Rod Stability and Mounting
Long compression strokes can be limited by rod buckling before pressure rating. Effective column length changes with mounting. Side load or a misaligned clevis increases bearing and seal stress.
Translate Speed Into Flow
Required flow equals effective area multiplied by piston velocity. Multi-speed cycles may need valve logic rather than one constant-flow source.
Centralina idraulica a corrente continua compatta serie EP-HPU-DC
EP-HPU-DC: unità di potenza idraulica compatta e configurabile per circuiti di cilindri alimentati a batteria o da veicoli.
Centralina idraulica a corrente alternata serie EP-HPU-AC
EP-HPU-AC: Centralina idraulica CA configurabile per sistemi di cilindri industriali fissi.
Centralina idraulica e sistema di valvole personalizzati serie EP-HPU-SYS
Il sistema di centralina idraulica e collettore valvole EP-HPU-SYS è stato progettato su misura in base al circuito del cilindro e al suo utilizzo.
Cilindro idraulico a foro passante saldato serie EP-WP da 3000 PSI
Serie di cilindri passanti saldati EP-WP con dimensioni del modello, pressione, carico di colonna e dati delle porte.
Frequently Asked Questions
Should I size from relief-valve pressure?
Use expected working pressure at the cylinder; treat relief setting as a protection limit.
Why is retract force lower?
The rod removes part of the rod-side pressure area.
Does a larger bore always solve a force problem?
It also raises flow demand and may exceed the installation envelope.
When does rod buckling matter?
When a long slender rod carries compression over a large effective length.
What dimensions belong in a sizing request?
Force or bore target, stroke, closed envelope, mounts, pins/flange, ports and load geometry.
Discuti le tue esigenze idrauliche
Inviare dettagli relativi a alesaggio, corsa, montaggio, pressione, porte, carico e utilizzo. Per le sostituzioni, includere foto e misure critiche.